Big Agnes Copper Spur UL1 manuale

(1)
  • Numero di pagine: 2
  • Tipo di file: PDF
Cut here to remove. Do Not Tear!

COPPER SPUR UL SETUP INSTRUCTIONS

1. Remove contents from stu sack. Spread the tent body out at on the ground.
2. Assemble the two poles: One main pole with two hubs and one short straight
crossover pole. To ensure each pole section is fully seated insert each pole section
into the next by hand, instead of allowing the shock cord to snap them together.
3. Position the assembled pole set on top of the tent body. CS1 & CS2: Align the or-
ange pole segments of the main pole set with the orange webbing at the foot of
the tent. CS3 & CS4: The pole set is symmetrical so the pole tips may be inserted
at either end.
4. Insert the pole tips into the grommets at the four corners of the tent.
5. Attach the H Clip on the top-center of the tent body to the Swivel CH hub on the
main pole. CS1: Attach H Clip to Swivel H.
6. Attach the Twist Clips on the tent body to the main pole.
7. Place the crossover pole across the top of the ridge pole and into the top of the
Swivel CH for CS2, CS3, & CS4. The cross pole on the CS1 is already attached to the
main pole.
8. CS1, CS2, CS3: Clip the ends of the crossover pole into the clear plastic Ball Cap
clips that are located above the doors on the tent body. CS4: Attach the H Clips
above the doors of the tent body to the S Stoppers on the cross pole.
9. Stake out the four corners of the tent body.
10. Drape the rainy over the tent body. CS & CS2: Align the silver and orange web-
bing straps on the rainy with those on the corners of the tent body. CS3 & CS4:
Align the doors on the y with the doors on the tents body.
11. CS4: Insert the tips of the cross pole into the webbing pockets located on the
underside of the y. Note: CS1, CS2 and CS3: The webbing pockets are used in
the Fast Fly set up only.
12. Make sure the webbing at the corners of the rainy is completely slackened. At-
tach the buckles on the rainy to those on the tent body.
13. Stake out the vestibules.
14. Evenly tension the webbing on each corner as needed to keep the rainy taut.
15. Stake out all guylines.
Separate 6”, large diameter pole segment included for emergency
eld repair. Slide repair pole over the break to act as a splint.

FAST FLY SET UP INSTRUCTIONS

If you purchase the optional Big Agnes footprint for any of our models, it will
enable you to pitch a Fast Fly shelter while leaving the tent body behind. The Fast
Fly conguration requires the footprint, tent y, poles and stakes.
1. Lay the footprint on the ground and stake out.
2. Assemble the two poles: One main pole with two hubs and one short straight
crossover pole. To ensure each pole section is fully seated insert each pole
section into the next by hand, instead of allowing the shock cord to snap them
together.
3. Position the assembled pole set on top of the footprint. CS1 & CS2: Align the
orange pole segments of the main pole set with the orange webbing on the
footprint. CS3 & CS4: The main pole has equal length pole sections so the pole
tips may be inserted at either end.
4. Insert the pole tips into the grommets at the four corners of the footprint.
5. Place the crossover pole across the top of the ridge pole and into the top of the
Swivel CH for CS2, CS3, & CS4. The cross pole on the CS1 is already attached to
the main pole.
6. Drape the rainy over the pole frame aligning the silver webbing on y with the
silver webbing on the footprint. Insert the tips of the cross pole into the web-
bing pockets located on the underside of the y.
7. Make sure the webbing at the corners of the rainy is completely slackened. At-
tach the buckles on the rainy to those on the footprint.
8. Stake out the vestibules.
9. Evenly tension the webbing on each corner as needed to keep the rainy taut.
10. Stake out all guylines.
Copper Spur UL1
Tent Body
Copper Spur UL1
Tent Fly
Ball Cap Swivel CH
H Clip Twist Clip
Swivel H S Stopper
Hardware:
Copper Spur UL3
Tent Body
Copper Spur UL4
Tent Body
Copper Spur UL4
Tent Fly
Copper Spur UL3
Tent Fly
Copper Spur UL2
Tent Body
Copper Spur UL2
Tent Fly

Ho bisogno di aiuto?

Numero di domande: 0

Hai domande sul Big Agnes Copper Spur UL1 o hai bisogno di aiuto? Fai qui la tua domanda. Fornisci una descrizione chiara e completa del problema e della domanda. Più dettagli fornisci per il tuo problema e la tua domanda, più facile sarà per gli altri proprietari di Big Agnes Copper Spur UL1 rispondere correttamente alla tua domanda.

Consulta qui gratuitamente il manuale per il Big Agnes Copper Spur UL1. Il manuale rientra nella categoria Tende ed è stato valutato da 1 persone con una media di 7.5. Il manuale è disponibile nelle seguenti lingue: Inglese. Hai domande sul Big Agnes Copper Spur UL1 o hai bisogno di aiuto? Fai la tua domanda qui

Specifiche Big Agnes Copper Spur UL1

Generale
Marca Big Agnes
Modello Copper Spur UL1
Prodotto Tenda
Lingua Inglese
Tipo di file PDF

Domande frequenti

Di seguito, troverai le domande più frequenti riguardo Big Agnes Copper Spur UL1 .

La tua domanda non è elencata? Fai la tua domanda qui