Big Agnes Slater UL2+ manuale

(1)
  • Numero di pagine: 2
  • Tipo di file: PDF
Cut here to remove. Do Not Tear!

SLATER UL SET UP INSTRUCTIONS

1. Remove contents from stu sack. Spread tent body out on ground.
2. Assemble the pole. To ensure each pole section is fully seated insert each pole section
into the next by hand, instead of allowing the shock cord to snap them together.
3. Insert the pole tips into the grommets at the front corners and foot of the tent.
4. Attach the H Clips to the underside of the S Stoppers.
5. Attach all Twist Clips to the pole.
6. Stake out the two cord loops at the head of the tent and the three loops at the foot.
7. Drape the rainy over the tent so that the door on the y lines up with the door
on the body.
8. On the underside of the y on each side of the tent are two clips sewn into the
hem opposite the guyline. Clip these to the corresponding webbing loop sewn
into the tent body. The loop on the tent body is located where the oor of the
tent meets the side wall.
9. Make sure the webbing at the corners of the rainy is completely slackened.
Attach the buckles on the rainy to those on the tent body.
10. Attach the two cord loops at the rear of the y to the stakes that you used for
the tent body.
11. Stake out the vestibule.
12. Evenly tension the webbing on each corner as needed to keep the rainy taut.
13. Stake out all guylines.
Separate 6”, large diameter pole segment included for emergency eld repair.
Slide repair pole over the break to act as a splint.

FAST FLY SET UP INSTRUCTIONS

If you purchase the optional Big Agnes footprint for your Slater tent it will enable
you to pitch a shelter while leaving the tent body behind. The Fast Fly conguration
requires the footprint, rainy, poles and stakes.
1. Lay the footprint on the ground and stake out.
2. Assemble the pole.
3. Insert the pole ends into the grommets at the front corners and rear of the footprint.
4. Drape the rainy over the tent.
5. Make sure the webbing at the corners of the rainy is completely slackened.
Attach the buckles on the rainy to those on the footprint.
6. Attach the two cord loops at the rear of the y to the stakes that you used for
the footprint.
7. Stake out the vestibule.
8. Evenly tension the webbing on each corner as needed to keep the rainy taut.
9. Stake out all guylines.
Slater UL1+
Tent Body
Slater UL2+
Tent Body
Slater UL1+
Tent with Fly
Slater UL2+
Tent with Fly

Hardware:

H Clip Twist ClipS Stopper

Ho bisogno di aiuto?

Numero di domande: 0

Hai domande sul Big Agnes Slater UL2+ o hai bisogno di aiuto? Fai qui la tua domanda. Fornisci una descrizione chiara e completa del problema e della domanda. Più dettagli fornisci per il tuo problema e la tua domanda, più facile sarà per gli altri proprietari di Big Agnes Slater UL2+ rispondere correttamente alla tua domanda.

Consulta qui gratuitamente il manuale per il Big Agnes Slater UL2+. Il manuale rientra nella categoria Tende ed è stato valutato da 1 persone con una media di 5.6. Il manuale è disponibile nelle seguenti lingue: Inglese. Hai domande sul Big Agnes Slater UL2+ o hai bisogno di aiuto? Fai la tua domanda qui

Specifiche Big Agnes Slater UL2+

Generale
Marca Big Agnes
Modello Slater UL2+
Prodotto Tenda
Lingua Inglese
Tipo di file PDF

Domande frequenti

Di seguito, troverai le domande più frequenti riguardo Big Agnes Slater UL2+ .

La tua domanda non è elencata? Fai la tua domanda qui