Name: Bosch Serie | 6 VarioPerfect
Brand: Bosch
SKU: 762891
Rating: 83 (204 reviews)

manualeBosch Serie | 6 VarioPerfect

en Instruction Manual and Installation Instructions

Washing machine

WAT...

Manuale

Consulta qui gratuitamente il manuale per il Bosch Serie | 6 VarioPerfect. Il manuale rientra nella categoria Lavatrice ed è stato valutato da 204 persone con una media di 8.3. Il manuale è disponibile nelle seguenti lingue: Inglese. Hai domande sul Bosch Serie | 6 VarioPerfect o hai bisogno di aiuto? Fai la tua domanda qui

Indice

Your new washing machine
Display rules
: Warning!
Caution!
Note/tip
1. 2. 3. / a) b) c)
Contentsen Instruction Manual and Installation Instructions
- 8 Intended use 4
- ( Safety instructions 5
- 7 Environmental protection 7
- 5 Positioning and connecting 8
- * Getting to know the appliance 16
- Z Laundry 19
- C Detergent 20
- 0 Programme default settings 21
- \ Additional programme settings 23
- 1 Operating the appliance 24
- H Sensors 29
- M Setting the signal 30
- 2 Cleaning and maintenance 30
- 3 Faults and what to do about them 33
- 4 After-sales service 38
- J Technical data 38
- r Aqua-Stop warranty 39
- 8 Intended use
  - Intended use
Children must not perform cleaning or maintenance work unsupervised.
- ( Safety instructions
- 7 Environmental protection
Overview of programmes
~ Supplementary sheet for the operating and installation instructions.
The display provides information about the relative energy consumption in the selected program.
The more indicator lights light up, the higher the program's consumption.
This enables you to compare the consumption levels of the different programs when choosing your program settings and to decide on an energy- and water-saving program setting for the selected program.
Energy-saving mode is not activated if a programme is running.
- 5 Positioning and connecting
- 1. Take the hoses out of the holders.
  - 2. Unscrew and remove all four transport brace screws.
Remove the sleeves. To do this, remove the mains cable from the holders.
- 3. Fit the covers. Lock the covers firmly in place by applying pressure to the snap-in hooks.
- Hose and cable lengths
  - Tip:
- Water inlet
- Water outlet
Make sure that:
The connection point must be secured using a hose clamp with a diameter of 24-40 mm (available from specialist dealers).
- Levelling
- 1. Loosen the lock nuts using a wrench, by turning it in a clockwise direction.
  - 2. Check the alignment of the washing machine with a spirit level, and adjust it if necessary. Change the height by turning the appliance feet.
All four appliance feet must stand firmly on the ground.
- 3. Tighten the lock nut against the housing.
In doing so, hold the foot tight and do not adjust its height.
The lock nuts on all four appliance feet must be screwed tightly against the housing.
- Electrical connection
- Before washing for the first time
  - Notes
- 1. Check the machine.
- 1. Turn off the water tap.
  - 2. Reduce the water pressure in the supply hose.
Maintenance – filter in the water supply ~ Page 32
- 3. Disconnect the washing machine from the main plug.
- 4. Drain the remaining detergent solution.
Maintenance – detergent solution pump blocked ~ Page 31
- 5. Remove the hoses.
- Installing the transport locks:
- 1. Remove the covers and keep them in a safe place.
Use a screwdriver if necessary.
- 2. Insert all four sleeves.
Clip the mains cable securely in the holders. Insert and tighten the screws.
- Notes
* Getting to know the appliance
- Getting to know the appliance
- Washing machine
- Control panel
  - Note:
- Display panel
  - Button
  - Display indicator
  - Description
- More information on the display panel
  - Display indicator
  - Description
  - Z Laundry
- Wash laundry with the same level of soiling together.
- You can find examples of levels of soiling on ~ Page 21
- The numbers in the symbols indicate the maximum washing temperature which may be used.
  - Starching
    - Note:
  - Dyeing/bleaching
  - Soaking
  - 1. Pour soaking agent/detergent into compartment II in accordance with the manufacturer's instructions.
- Suitable for boil-washable white laundry made from linen or cotton
- Programme: Cottons/
- cold - max. 90 °C
- Suitable for coloured laundry made from linen or cotton
- Programme: Cottons/
- cold - max. 60 °C
- Suitable for coloured laundry made from easy-care fibres, synthetic fibres
- Programme: Easy-Care/
- cold - max. 60 °C
- Suitable for delicate, fine fabrics, silk or viscose
- Programme: Delicate/Silk/
- cold - max. 40 °C
- Suitable for wool
- Programme: Wool/
- cold - max. 40 °C
  - Saving energy and detergent
  - 0 Programme default settings
  - To do this:
  - 1. Select a program.
- The program duration is displayed for the selected program, e.g. 2:30 (hours:minutes).
  - 2. Press the Finished in-time button repeatedly until the required number of hours is displayed.
  - 3. Press the A button.
- The door will be locked.
- The selected number of hours (e.g. 8 h) is shown in the display panel and counts down until the wash program starts. The duration of the program is then displayed.
  - During the timer count-down, you can change the preselected number of hours as follows:
  - 1. Press the A button.
  - 1. Press the A button.
- Washing in a shorter time while achieving a washing result that is consistent with, but uses more energy than the selected program without the Speed setting.
  - Note:
- Energy-optimised washing by reducing the temperature while achieving a washing result that is consistent with the selected program without the Eco setting.
  - Easy-Iron
    - Note:
  - Prewash
    - Note:
  - Water Plus
  - Rinse Plus
  - 1 Operating the appliance
    - Operating the appliance
    - Preparing the washing machine
      - Note:
  - 1. Connect the mains plug.
  - 1. Place presorted items of laundry unfolded in the washing drum.
    - 2. Make sure that no items of laundry are trapped between the washing machine door and the rubber seal, and close the door.
    - The A button indicator lamp flashes to indicate that the washing program can be started. It is possible to change the settings. ~ "Dyeing/bleaching" on page 20~ "Spin speed" on page 21
      - Measure and add detergent and care products
        Caution!
        Damage to the appliance
        : Warning
        Eye/skin irritation!
        Note:
  - 1. Pull out the detergent drawer as far as possible.
  - 1. Pull out the detergent drawer. Press down the insert and fully remove the drawer.
  - 1. Press the A button.
  - 1. Press the A button.
  - 1. Press the A button.
  - 1. Open the door and remove the laundry.
  - Activating the setting mode
    - 1. Select the i Cottons program at position 1. The washing machine is switched on.
    - 1. Pull out the detergent drawer. Press down the insert and fully remove the drawer.
  - After the water has cooled down:
    - 1. Turn off the water tap so that no more water can flow in and has to be drained via the drain pump.
- Remove the sealing cap, allow the water to flow out into a suitable container.
- Replace the sealing cap and place the drainage hose in the retainer.
  - 6. Carefully unscrew the pump cover, residual water may leak out.
- Clean the interior, pump cover thread and pump housing. The impeller in the detergent solution pump must be able to rotate.
- Refit the pump cover and screw it on tightly. The handle must be in a vertical position.
  - 7. Place the service flap back on, lock it into place, and close it.
  - Note:
  - The drain hose at the siphon is blocked
  - 1. Switch off the appliance.
  - 1. Turn off the tap.
- Disconnect the hose from the tap.
- Clean the filter with a small brush.
  - 7. For standard and Aqua-Secure models, clean the filter on the rear of the appliance:
- Remove the hose from the rear of the appliance.
- Use pliers to remove the filter and then clean it.
  - 8. Insert the filter, connect the hose and check for leaks.
  - 3 Faults and what to do about them
    - Faults and what to do about them
    - Emergency release
      - Note:
        : Warning
        Risk of scalding!
        : Warning
        Risk of injury!
        Caution!
        Water damage
  - If the laundry has to be removed, the washing machine door can be opened as follows:
    - 1. Switch off the appliance.
- The washing machine door can now be opened.
  - Information on the display panel
  - Faults and what to do about them
  - You can find this information:
- Our warranty does not cover defective feed lines or fittings leading to the Aqua-Stop connection at the tap.
  - 4. Appliances with Aqua-Stop do not need to be supervised during operation, nor secured afterwards by turning off the tap.
- The tap only needs to be turned off if you are away from home for a long period, e.g. for several weeks' holiday.

Ho bisogno di aiuto?

Hai una domanda relativa a Bosch e la risposta non è nel manuale? Fai qui la tua domanda Fornisci una descrizione chiara e completa del problema e della tua domanda. Migliore sarà la descrizione del tuo problema e della domanda, più facile sarà per gli altri proprietari di Samsung Galaxy A7 fornirti una buona risposta.

Cambiotti Simonetta • 29-4-2022 Non ci sono commenti

Cosa fare quando sul display lampeggia E18?

Rispondi a questa domanda

Silvana • 14-4-2022 Non ci sono commenti

Mentre lava lampeggia la chiave sul display. Cosa fare?

Rispondi a questa domanda

Nicoletta • 11-4-2022 Non ci sono commenti

Aprire oblò bloccato

Rispondi a questa domanda

Numero di domande: 3

Specifiche Bosch Serie | 6 VarioPerfect

Di seguito troverai le specifiche del prodotto e le specifiche del manuale di Bosch Serie | 6 VarioPerfect.

Generale

Marca	Bosch
Modello	Serie \| 6 VarioPerfect
Prodotto	Lavatrici
EAN	4242002904825
Lingua	Inglese
Tipo di file	PDF

Design

Posizionamento dell'apparecchio	Libera installazione
Tipo di carica	Caricamento frontale
Colore del prodotto	Bianco
Display incorporato	Sì
Cerniera porta	Sinistra
Illuminazione display	Sì
Materiale cestello	Acciaio inossidabile
Colore della porta	Trasparente
Tipo di controllo	Buttons,Rotary
Tipo motore	Senza spazzola
Certificazione	CE, VDE
Tipo di display	LED

Gestione energetica

Classe di efficienza energetica (vecchia)	A+++
Consumo di energia per lavaggio	- kWh

Prestazione

Sistema di bilanciamento carico	Sì
Capacità cestello	8 kg
Velocità di centrifuga massima	1200 Giri/min
Classe di efficienza della centrifuga	B
Umidità residua	53 %
Timer	Sì
Silenziosità (lavaggio)	51 dB
Durata ciclo (programma rapido)	15 min
No risciacquo	Sì
Silenziosità (centrifuga)	76 dB
Partenza differita	Sì
Partenza ritardata	24 h
Velocità di centrifuga regolabile	Sì
Programmi di lavaggio	Hygiene/anti-allergy,Black

Altre caratteristiche

Classe efficacia di lavaggio	A
Consumo energetico annuale	177 kWh
Consumo annuale di acqua	9460 L

Ergonomia

Indicatore programma LED	Sì
Indicatore del tempo rimanente	Sì

Dimensioni e peso

Larghezza	598 mm
Profondità	585 mm
Altezza	848 mm
Peso	65000 g

Dati su imballaggio

Peso dell'imballo

66000 g

Mostra di più

Domande frequenti

Non riesci a trovare la risposta alla tua domanda nel manuale? Puoi trovare la risposta alla tua domanda nelle FAQ sul Bosch Serie | 6 VarioPerfect che trovi di seguito.

La tua domanda non è elencata? Fai la tua domanda qui

Nessun risultato

Bosch Serie | 6 VarioPerfect manuale

manualeBosch Serie | 6 VarioPerfect

Manuale

Indice

Ho bisogno di aiuto?

Specifiche Bosch Serie | 6 VarioPerfect

Generale

Design

Gestione energetica

Prestazione

Altre caratteristiche

Ergonomia

Dimensioni e peso

Dati su imballaggio

Domande frequenti

Manuali dei prodotti correlati

Bosch Classixx 6 VarioPerfect

Bosch Maxx 7 VarioPerfect

Bosch Serie | 6 WAT283L8SN

Bosch Serie 6 WAT24638IT

Bosch Serie 6 WVH28471EP

Bosch Serie 6 WAU28PH9GB

Bosch Serie | 6 WAT284B9SN

Bosch Serie | 6 WAT24468ES

Bosch Serie 4 WAN282EURO

Bosch Serie 6 WAT28438II