Whirlpool ADP 8453 manuale

Whirlpool ADP 8453
7.5 · 1
PDF manuale
 · 8 pagine
Inglese
manualeWhirlpool ADP 8453
GB -1-

Chart

(see at right for options description)
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the program.
When the door is opened during a washing cycle,
the cycle is temporarily paused: the Start indicator
blinks. To resume the cycle close the door and
push Start button again.
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute
(0:01 is shown into the display).
If pressed when the dishwasher is switched off,
it drains any possible liquids from dishwasher
(1 minute process).
PROGRAM SELECTION
BUTTON
Push “P” button (repeatedly)
until selected program number
is shown on the display
(P1...Px) - see “Table of
programs” below.
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may
vary depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic
calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/
Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.
3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.

Table of programs

Deter-
gent
Consumption
Drying
Phase
Programs
Available
options
Loading instructions
Litres kWh
Minutes
1)
P1
Sensor 40-70°C
DelayHalf loadRecommended program for routine washes, with dried-on food (e.g. EN 50242).X 7-14 1.00-1.60 70-155 Full
P2
Pre-Wash cold
Delay Crockery to be washed later. 4.0 0.03 14 NO
P3
Fragile 40°C
DelayLight soiling, for example glasses and cups.
X 10.0 0.85 100 Light
P4
Rapid 45°C
DelayLightly soiled crockery, with no dried-on food.X 11.0 0.80 30 NO
P5
Eco
2)
50°C
DelayHalf loadNormally soiled crockery. Energy-saving program.
X 11.0 0.92 230 Full
P6
Fast Daily 60°C
DelayHalf load
Normally soiled crockery. X 10.0 1.30 80 Full
P7
Steam
DelayProgram including steam action dedicated for heavily soiled crockery, pots and pans. Soaking or hand pretreatment is no longer needed.
X 14.0 1.70 180 Full
P8
Hygiene
3)
DelayNormally or heavily soiled crockery, with additional antibacterial wash. Program interruption (e.g. due to door opening) can compromise elimination of germs.
X 13.0 1.50 118 Full

5019 396 03622

Options and display description
SALT INDICATOR
When lit (at the end of the cycle),
the salt reservoir needs to be
refilled.
HALF LOAD BUTTON
Half load cycle can be used for the
upper or lower rack. Select the
required program then press the
“Half Load” button - the light
comes on. Turns off at the end of
the program.
The “Half Load” option can be
used with the programs
indicated in the table of
programs.
TABLET SETTING
This setting allows to optimize the cycle performances
according the type of detergent used.
Push the Tablet button for 3 seconds (until the indicator lights
up) if you are using the combined detergents in tablet (rinse aid,
salt and detergent in 1 dose).
If you are using powder detergent or liquid detergent, the
Tablet indicator on the control panel has to be off.
DELAYED START BUTTON
Push the button (repeatedly)
to delay the start of the
program. Adjustable from 1 to
24 hours. With each press of
the button, the delayed start
indicator increases by one
hour and after 24 restarts from
0. Then press the START
button. The dishwasher will
start after the set time.
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to
be refilled.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates
the time remaining until program start (h.00) - below 1h (0:min).
If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS
QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY
BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
Quick reference guide
Whirpool is a registered trademark of Whirpool USA

Consulta qui gratuitamente il manuale per il Whirlpool ADP 8453. Il manuale rientra nella categoria Lavastoviglie ed è stato valutato da 1 persone con una media di 7.5. Il manuale è disponibile nelle seguenti lingue: Inglese. Hai domande sul Whirlpool ADP 8453 o hai bisogno di aiuto? Fai la tua domanda qui

Ho bisogno di aiuto?

Hai una domanda relativa a Whirlpool e la risposta non è nel manuale? Fai qui la tua domanda Fornisci una descrizione chiara e completa del problema e della tua domanda. Migliore sarà la descrizione del tuo problema e della domanda, più facile sarà per gli altri proprietari di Whirlpool fornirti una buona risposta.

Numero di domande: 0

Generale
Whirlpool
ADP 8453
Lavastoviglie
Inglese
Manuale d'uso (PDF)

Non riesci a trovare la risposta alla tua domanda nel manuale? Puoi trovare la risposta alla tua domanda nelle FAQ sul Whirlpool ADP 8453 che trovi di seguito.

La tua domanda non è elencata? Fai la tua domanda qui

Nessun risultato